English
中文
Download
Glue saving and environmental protection: The gluing machine can accurately control the amount of glue used to avoid waste, and use environmentally friendly glue to reduce the impact on the environment.
1
Connect the single-phase 220V power supply, connect the air source, and check if the four pointers of the recessed cylinder are working properly. Click the 'Reset' button to check if the device is functioning properly.
2
Switch to debugging mode, replace the mold, and adjust the machine position.
3
Log in to the manual page, click on "Mold opening servo" or "Mold opening assistance descent", level the bottom and middle of the upper mold, then switch to the "Settings page", long press "Upper mold" to set the position.
4
Log in to the manual page, click on "Spindle Servo Downward" to lower the spindle servo to the position of the impact angle cylinder, click on "Impact Angle Cylinder" to start the impact angle flat brush, adjust the bottom of the flat brush to a position 5-8mm higher than the bottom of the inner box, log in to the settings page, and long press "Impact Angle" to set the position.
5
Log in to the manual page, click "Spindle servo descending", and the spindle servo descends to the foam plate position.
