English
中文
Download
The double-station press machine is designed with two working positions, and each position can complete the press operation independently. When one station is performing the press operation, the other station can load or unload materials at the same time, thus realizing the continuous operation of the production line. This design not only reduces the idle time of the equipment, but also makes the production process smoother and effectively improves production efficiency.
1
Connect the single-phase 220V power supply, connect the air source, and check if the four pointers of the recessed cylinder are working properly. Click the 'Reset' button to check if the device is functioning properly.
2
Switch to debugging mode, replace the mold, and adjust the machine position.
3
Log in to the manual page, click on "Mold opening servo" or "Mold opening assistance descent", level the bottom and middle of the upper mold, then switch to the "Settings page", long press "Upper mold" to set the position.
4
Log in to the manual page, click on "Spindle Servo Downward" to lower the spindle servo to the position of the impact angle cylinder, click on "Impact Angle Cylinder" to start the impact angle flat brush, adjust the bottom of the flat brush to a position 5-8mm higher than the bottom of the inner box, log in to the settings page, and long press "Impact Angle" to set the position.
5
Log in to the manual page, click "Spindle servo descending", and the spindle servo descends to the foam plate position.
